We know from our marking tape material such as plastic particles involved in the blown film machine, blown plastic film, the width is usually 1.3M or so, according to the tape use, choose a different plastic particles, and participate in some special additives, and secondly we probably watching then after blowing up the film coater coating glue, this process is mainly based on the viscosity and use tape packing belt production line needs to choose the glue.
　　Then this is the large rolls of plastic film over again through the winder roll into small rolls of film, which is based on the length of our usual use of tape rewinding require further attention to matters of custody of marking tape: tape type specification according to the needs and specific conditions of use, a reasonable choice, the tape should be deposited in the Treasury, to avoid the sun and rain, to stop the oil and acid-base organic solvent exposure, adhere to wash monotonous from the device found outside 1m, room temperature - between 15 ℃ ~ 40 ℃ marking tape reminds us: Do not allow hunting or crawling tape to adhere to drag roller, vertical roll active, the tension should be appropriate conveyor with baffles and clean equipment when installed, should be avoided wear and tear tape, the tape should be placed in a roll, not folded, too long storage time should be turned over once every quarter.